Re: probleme de son + affichage dans rscenter
ça doit être ça je pense (je voulait envoyer le dossier mais j'ai pas trouvé comment faire)
;Here you can edit some sound effects volumes
;A valid value is between 0 and 1.
;using larger numbers than 1 is ok , interal clamping!
;still all sounds are assigned to a specific volume controller ingame.
;
;Name ; Assigned to volume controller ingame
[AMP::SOUNDS]
Engine=1.0 ; engine
EngineTransmission=0.8 ; engine
TransmissionDiff=0.6 ; engine
Turbo=0.3 ; effects
BlowOffValve=0.4 ; effects
DriveShaftBroken=1.0 ; effects
GravelParticles=0.6 ; effects
Squeeks=2.0 ; effects
Suspension=0.6 ; effects
Horn=0.5 ; effects
Helicopter=0.3 ; effects
Bird=1.0 ; effects
Wind=0.5 ; effects
EnviormentalReflections=1.0 ; engine
Offtrack=0.5 ; effects
Pop=2.0 ; effects
ExhaustPop=0.7 ; effects
Bang=1.0 ; effects
Ignition=0.5 ; effects
Enginefire=1.0 ; effects
BrokenCooler=1.0 ; effects
WiperEngine=0.25 ; effects
Wiper=0.25 ; effects
Impacts=1.0 ; effects
ImpactScreams=0.5 ; effects
Servicepark_BG=1.0 ; effects
Servicepark_FX=1.0 ; effects
Rain=1.0 ; effects
[OPTIONS::SOUNDS]
NumberChannels=0 ; 0 means use all hardware channels
; 32 means 32 audiochannels
; don't exceed your hardware spec in channels, slowdowns
EnableEQOnCars=true ; enable equlizer on the engine sound.
;Equalizer
; I have added a equalizer on the enginesound so you people can change and make the cars
; sound a little diffrent from eachother
; EQ_NOLOAD = No load on the engine eq
; EQ_FULLLOAD = Full load on the engine eq
; Eq changes depending on the engine load
; example: 50% load is 50% of the NOLOAD EQ and 50% of the FULLLOAD EQ
; example: 80% load is 20% of the NOLOAD EQ and 80% of the FULLLOAD EQ
; only available if EnableEQOnCars=true
; good values to use are between -1.0 to 2.0
; a value above 0.0 will boost the band.
; a value below 0.0 will reject the band.
; But as with all humans , if you give them a hand they'll take the arm.
; Use whatever values you want.
; I have an compressor running on the enginesound at around -6dB with 4:1 ratio.
; With 256x internal oversampling you should be able to crank up the frequencies pretty much.
;
; I have played with the Subaru'03
; To enable it , set EnableEQOnCars=true
;
; have fun!
;Citroen
[EQ_NOLOAD::CAR1]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR1]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Hyundai
[EQ_NOLOAD::CAR2]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR2]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;MG
[EQ_NOLOAD::CAR3]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR3]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Mitsubishi
[EQ_NOLOAD::CAR4]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR4]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Peugeot
[EQ_NOLOAD::CAR5]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR5]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Subaru '03
[EQ_NOLOAD::CAR6]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR6]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Toyota
[EQ_NOLOAD::CAR7]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR7]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
;Subaru '00
[EQ_NOLOAD::CAR8]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
[EQ_FULLLOAD::CAR8]
31Hz=0.0
62Hz=0.0
125Hz=0.0
250Hz=0.0
500Hz=0.0
1KHz=0.0
2KHz=0.0
4KHz=0.0
8KHz=0.0
16KHz=0.0
; Audio.DAT information!
; 1) Extract all Audio.dat files somewhere (with the directory structure)
; I have seen tools around that extracts .dat files.
; Try Richard Burns Rally forums at
http://www.bhmotorsports.com to find one.
; 2) Copy the extracted Audio directory to your installed RBR folder
; creating a new folder called Audio
; 3) Rename the Audio.dat file to something else (audio.data works nice or whatever pleases you)
; 4) The game will now read audio data from the new Audio folder.
;
; This should make audiomoding a little bit easier.
;
-- Fusion automatique le Mar 13 Oct 2009 13:58 --
J'ai une petite précision que j'avais oublié j'ai le son dans le menu quand je sélectionne le profil,ça coupe juste après.Merci pour l'aide